Hampton Bay 14693 Guida di Installazione Scaricare il pdf (Pagina 6)

ASSEMBLY AND INSTALLATION INSTRUCTIONS:

1. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.

2. Tighten support screws (long) full turns into the inside mounting hole of mounting strip (to be fully

tightened later) secure by hex nut. This support screws (long) should extend long enough to

protrude through the canopy when it is mounted.(Adjust as needed)

3. Fasten the mounting strip onto outlet box using two outlet box screws (short).

4. Put the fixture wires through each tube and canopy assembly, then tighten tubes and canopy assembly

until secured respectively as diagram 1. (There are three options for you to chose from.)

5. Connect the wire from the fixture to the power supply wire from outlet box. Cover with wire connectors.

A. Twist together white wire from the fixture with white wire from outlet box. Cover with wire connector.

B. Twist together black wire from the fixture with black wire from outlet box. Cover with wire connector.

C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw on

mounting strip before it is connected to the grounding conductor of the supply circuit.

6. Carefully position all wiring inside outlet box.

7. Place the canopy over the outlet box, let the heads of support screws (long) come through the holes of the

canopy, then tighten the cap nuts to the protruding support screws on mounting strip until the canopy is

held firmly against the ceiling.

8. Unscrew the socket ring from the socket. Set glass shade onto the socket and secure socket ring by socket

ring key.

9. Install the bulb (not included). Use 60-watt Maximum standard type A bulb or MAX 13W UL LISTED

CFL bulb. .

10. Turn on the electrical power in your house or building to activate the mini pendant.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Nessun commento

Hampton Bay 14693 Guida di Installazione Pagina 6